![]() Here's a pic of the inside of the case atm. Corsair Air 540, I7 9900k, ASUS ROG Maximus XI Hero, G.Skill Ripjaws 3600 32GB, 3090FE EVGA 1000G5, Acer Nitro XZ3 2560 x 1440240hz. Then I will spend the weekend finishing up this simple mod. When I order that, probably next week, I will order the carbon fiber sheets from Dragonplate Carbon too. That is getting replaced with a Noctua U12S in black. Right now, I am using a Cooler Master Hyper 212 EVO with push pull Corsair fans. I did add feet I stole from a Silverstone FT03 case which raises the pc another 3/4" off my desk.Īs I use this PC on a daily basis, it had to be thrown together before the case was done. At this time, I should have cut the holes for the bottom fans as well, but I didn't, so when the carbon fiber comes, I will empty the case and do that. Aku suka dengan design CM Masterbox Q300L, clear panel yang menunjukkan semua komponen PC memang satu ciri PC case yang menarik. I like that it uses a plexi window instead of glass, has movable I/O and has some nice flat surfaces that I can cover with carbon veneer sheets (the real stuff).įirst thing I did was take a dremel to the top 140mm opening I need and also the rear 120mm opening. ![]() So I get the case and yeah, its cheap all right, but I do like it. ![]() It will fit all of my hardware as I have gone air cooling for this update. Now the pump is even more in focus and the over all design is less boxy. I cut my shroud open after the pump cover and I felt I had made a great improvement. So I get the case and yeah, its cheap all right, but. Its tiny for an atx case, which I like a lot. In comes Cooler Master's Q500L Atx pc case. Its tiny for an atx case, which I like a lot. After going back to the original shroud from Cooler Master and it’s angled design with a more narrow top I had my inspiration and tribute. I have really modded a case in a while and wanted to do some real carbon fiber on it, so I wanted to start cheap with the case. I have really modded a case in a while and wanted to do some real carbon fiber on it, so I wanted to start cheap with the case. I haven't changed my main workstation's case in two years, so it was time for something new. I get bored with my rigs (and collect cases), so I swap cases pretty often on several of my pcs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |